top of page
  • Writer's pictureAdmin

Mistakes To Avoid During Installing Timber Decking Supplies

Updated: Aug 2, 2022

We all make mistakes being human beings. Some of these mistakes are smaller and some are bigger. Turning left when we should have turned right, small mistake. Missing out on timber decking specifications and having to begin again, big mistake!

In this piece of information, we will be reading some of the most common mistakes while installing timber decking supplies.

Necessary Permits

It is important for you to apply (if required) for required building permits before you purchase any materials, dig holes, and nail boards together and get them approved. Therefore, it does make sense to check with your county, town, sub-division, city, and homeowners' association for required permits. The point is to ensure that you have all permits before you start with construction so that any inspector or local authority cannot demand that you bring it all down.

Poor Board Layout

There is no denying the fact that poor board layout or the use of short board lengths is one of the biggest mistakes. This leads to a huge waste of the timber decking board that further translates into top-up orders, going off the budget, and more time and effort required to install the timber deck. It is extremely important for you to trust only a reputed timber deck provider for decking in Sydney and decking in Sutherland Shire that has experienced and knowledgeable staff. This can easily eliminate a lot of problems even before the decking project gets started.

Under-Estimation Of Decking Board Quantity

At times, timber decking projects can go well over the budget because of poor decision-making and planning. Wastage because of odd-shaped timber decks, laying boards at a 45-degree angle, etc. that are out of shape can dramatically increase the time and efforts involved. Therefore, it is extremely important that you select only reputed decking in Sydney and decking in Sutherland Shire service providers so that you can always have complete peace of mind.

Choosing The Wrong Boards And Fasteners

It is important to always remember that each material has its own set of advantages and disadvantages. Therefore, it becomes all necessary to select the right products as per specifications for the desired results. Some timber decking boards can be easily nailed by making the use of angular grooved nails in place of jolt head nails. Alternatively, some decking situations may require pre-drilled, screwed, or countersunk options.

Bolt and Splice Beams

For durability and sustainability, it is extremely important to avoid bolting the deck beams directly to any of the support post sides. This is one of the most common mistakes with small to average size decks with usually a fewer number of posts. It is critical to note here that the fewer the count of posts, the greater the load will be on the connections of beams. The increased load will for sure distort the wood around the bolt and weaken the overall connection if a beam is bolted to the post sides.

Therefore, it is considered a good choice to connect the beams directly over posts by making use of the correct deck fasteners. Moreover, beam splices must always be positioned directly over deck posts as this minimizes deflection and bending. It may be required to add on additional posts, sunk to the right depth if it is not possible to position splices over existing posts.

70 views0 comments
bottom of page