Tips For Installing A Wall-Mounted Handrail The Right Way!

Did You Know That Stairwells Have More Accidents Than Any Other Room In The House?

Handrails are considered a vital safety feature in any two-story or split-level home, and they should be installed as soon as feasible. If not for yourself, then for any young or elderly relatives you could live with, suggests antique brass handrail maker. The good news is that installing a wall-mounted handrail is a low-cost, do-it-yourself activity. You don't need any specific tools or prior knowledge; just some common sense and elbow grease! We'll guide you through the whole procedure from beginning to end, ensuring that you end up with a pretty antique brass handrail that not only looks fantastic but also lasts!

Before You Begin

Before making any changes to your staircase, we always recommend double-checking your local Australian building code, especially in commercial situations. Handrail regulations are always changing, therefore the advice described below may not be applicable in your location outside of Australia.

What You'll Require

Quality antique brass handrail, Brackets for Handrails, Painter's tape, a pencil, Level Stud Finder with Tape Measure, Screws for Timber/Wood and a drill!

Instructions

Find Your Studs

Run your stud finder along the wall where you want to put your handrail. In general, studs should be positioned around 450mm apart. So, after you've found your first stud, the remainder should be rather simple to discover. Once you've located a stud, mark a long, vertical line through the middle with a level and either painter's tape or a pencil. This will assist you in determining the optimal location for your wall brackets in the following antique brass handrail installation phase.

Mark The Locations Of Your Brackets

Mark a point along your guideline between 865 and 125 (mm) past the nose of the stair steps with the same tools as earlier. These markings reflect the top edge of your antique brass handrail and should only be used as a reference, not the final placement on your bracket. The total height of the rail is primarily an issue of personal view, however, experts suggest 1m in most cases.

Line up the top end of the antique brass handrail against the pencil marks with the aid of a few others. Replace the reference markings at the bottom of your handrail where it meets the studs.

Measure And Cut Your Handrail To The Desired Length

If not, measure and cut the railing to the length you want. Handrails are generally spread between 250 and 300mm past the top and bottom stairs, so keep this in mind. It's also a good opportunity to paint or stain your rail and instal any end caps or fittings.

Fix Brackets To The Wall

Place the tops of your handrail brackets on the studs' indicated locations. From here, you should be able to mark and pre-drill your holes. Check that your antique brass handrail bracket is at the right angle. You should be able to use the markers for the top and bottom as a reference.

Every bracket will have a unique means of attaching to the wall, thus there is no one-size-fits-all answer here. If you have any questions about handrail brackets, antique brass handrail experts be pleased to address them by email or phone.

Connect The Handrail To The Brackets

Place your antique brass handrail above the brackets and secure it using screws. If you want to avoid splitting, drill small pilot holes first. This is especially critical if you're working with old brass rails.